VISUAL HOMEOWNER GUIDE · HEATING CYCLE

Observe what happens—without opening the furnace

A short, careful observation can give a technician useful information. It is not a substitute for testing or diagnosis.

← Back to the furnace troubleshooting guide
Four illustrated steps: create a call for heat, listen and watch a closed furnace, check warm air at a floor supply, and record what happens
  1. 1

    Create a call for heat

    Set the thermostat to Heat and raise the target temperature about 2–3°C above the displayed room temperature.

  2. 2

    Listen and watch

    From a safe distance, observe the completely closed furnace. Note whether it starts, stops, repeats a sequence, makes an unusual sound or displays a visible status light.

  3. 3

    Check a supply register

    After several minutes, hold your open hand above a nearby supply register without touching or removing it. Note whether airflow begins and whether it feels warm, cool or absent.

  4. 4

    Record the pattern

    Write down the time, thermostat message, visible fault code and sequence you observed. A short video taken from a safe distance may also help explain the concern.

What this check can tell you: the visible operating pattern and what the air feels like at one supply. It cannot confirm combustion safety, airflow quantity, electrical condition or the failed component.

CLEAR NEXT STEPS

Share the operating pattern with us

NorthShieldClimate Inc. is a TSSA-registered Heating Fuels Contractor (FS-R-53731) serving Toronto and the GTA, with direct communication, careful workmanship, and clear next steps for every inquiry.