FURNACE TROUBLESHOOTING · TORONTO & GTA

Furnace not heating?

A furnace that stops heating does not automatically require replacement. Start with a few safe checks, then know when to stop and request professional diagnosis.

Safe checks you can make

  1. Thermostat: Confirm it is set to Heat and above the current room temperature.
  2. Display: Check whether the thermostat is working and replace its batteries if applicable.
  3. Power: Confirm the furnace power switch is on.
  4. Electrical panel: Check for a tripped furnace breaker. Do not repeatedly reset a breaker that trips again.
  5. Filter: Replace it if it is visibly dirty, wet or deformed. Install the correct size in the airflow direction marked on the filter.
  6. Air openings: Make sure supply registers and return-air grilles are not blocked.
  7. Outdoor vents: From outside, visually confirm that the furnace vent openings are not covered by leaves, snow or ice. Do not dismantle the vent or insert anything into it. See the visual exterior-vent guide
Illustration showing a homeowner safely setting the thermostat to heat
Set the thermostat to Heat and above the room temperature. See the visual thermostat guide
Illustration showing a safe furnace filter inspection
Check the filter’s condition, size and airflow direction. See the visual filter guide
Illustration showing supply air moving into the room and return air moving into the return grille
Keep supply registers and return-air grilles open and unobstructed. See the visual airflow guide
Illustration encouraging homeowners to observe the furnace without opening it
Observe sounds, lights and operating patterns without opening the furnace. See the visual observation guide
Illustration warning homeowners not to remove furnace panels
Do not remove furnace panels or reach inside the equipment.
Illustration warning homeowners not to bypass furnace safety controls
Do not bypass door switches, limits or other furnace safeties.
Illustration warning homeowners not to touch furnace gas controls or wiring
Do not touch gas controls, wiring or internal components.
Illustration warning against repeatedly resetting a furnace fault
Do not repeatedly reset a fault, breaker or safety control.
Illustration showing when to stop and call a qualified contractor
Stop and request service when the problem repeats or warning signs appear. See the stop-and-call guide

A restricted filter can make a furnace work harder. Ontario safety guidance also recommends keeping fuel-burning appliance vents clear and having fuel-burning equipment inspected by a registered contractor. Enbridge appliance safety · TSSA carbon-monoxide guidance

Stop and request help when

  • The furnace starts and repeatedly shuts down.
  • A breaker trips again after being reset once.
  • You see water, scorching or damaged wiring.
  • The furnace makes unusual banging, grinding or buzzing sounds.
  • A carbon-monoxide alarm activates.
  • You smell natural gas.

CLEAR NEXT STEPS

Furnace service in Toronto and the GTA

NorthShieldClimate Inc. is a TSSA-registered Heating Fuels Contractor (FS-R-53731) serving Toronto and the GTA, with direct communication, careful workmanship, and clear next steps for every inquiry.